Box Contents
When you receive your handset, the box will contain:
Base station
W73P or W73H handsety charging cradle
Power adaptor
Ethernet cable
Rechargeable battery
Quick start guide
Set Up
To connect your handset, plug in the Ethernet cable from the base station to your internet router or network switch. Then plug in the power adaptor. Once the base LED turns solid, the base is powered and connected.
💡If your network supports Power Over Ethernet (PoE), the power adaptor is not needed.
Insert the battery into the handset and close the cover. Place the handset onto the charging cradle for at least 30 minutes for the initial charge. Turn on the handset by holding the red End Call key until the screen lights up.
Register the handset to the base by holding the Paging/Registration button until the LED flashes. On the handset, go to Menu, then Settings, and then Registration. Then select Register Handset. Select the base (e.g. Base 1) and enter the default PIN 0000. Once registered, the handset will show the base name and signal bars.
Troubleshooting
Issue | Solution |
No power lights | Ensure the power adaptor is connected and the plug socket works. |
No dial tone | Check the phone cord is firmly plugged into the handset. Restart the Analogy Telephone Adaptor (ATA). |
No network light | Ensure the Ethernet cable is connected to your router. Try another port. |
Unable to make calls | Wait 2 to 3 minutes after powering up for the ATA to register. Check your internet connection. |